web analytics

New Passleader Cisco 642-780 Practice Tests Dumps Download For Free (51-60)

QUESTION 51
Refer to the exhibit. Given this partial configuration, which statement is true?
511

A.    The 209.165.200.230 router is a P router.
B.    The 209.165.200.230 router is a CE router.
C.    The 209.165.200.230 router is a PE router.
D.    The 209.165.200.230 router is a customer router behind the CE router.

Answer: C

QUESTION 52
Refer to the exhibit. The command was executed on a Cisco ASR 9000 Series Router. Which statement is true?
521

A.    The tunnel, tunnel-te1, has been configured to be used by the IGP.
B.    A maximum of 1 kb/s of traffic can pass through tunnel-te1.
C.    Traffic on tunnel-te1 will pass through two other routers before reaching the tail-end router.
D.    When an echo request is sent through the tunnel-te1, the echo-reply will come back through tunnel-te1.

Answer: A

QUESTION 53
What does the MP-BGP AFI identifier indicate?

A.    which protocol an update is for
B.    whether updates are for MPLS VPN or MPLS TE
C.    whether or not route targets are present in the update
D.    which extended community attribute is being carried
E.    which VRF information is being carried in the update

Answer: A

QUESTION 54
Refer to the exhibit. The output from the debug command is from the Cisco XR12000 Series Router. Which statement is true?
541

A.    The output is the result of a single iteration of mpls ping executed on the Cisco ASR 9000 Series Router.
B.    The output is the result of a single iteration of mpls traceroute executed on the ASR 9000.
C.    The packet did not reach its destination because the control word was not found.
D.    The output is the result of a single iteration of mpls ping executed on the Cisco CRS-1 Carrier Routing System.

Answer: B

QUESTION 55
Refer to the exhibit. An operator is about to enter this configuration into a PE router. What is the problem with this configuration?
551

A.    It uses the wrong command for starting immediately.
B.    The prefix must be specified in dotted decimal notation.
C.    It does not specify the test protocol first.
D.    The schedule line should begin “schedule ipsla”.

Answer: C

QUESTION 56
Refer to the exhibit. Based on the MPLS header, what class of traffic is matched against the “match mpls experimental 0” packet?
MPLS header: 0x00 0x05 0x4B 0x7E
class-map match-any high-priority
match mpls experimental 5
class-map match-any app-data
match mpls experimental 1 3 4
class-map match-any internet

A.    class high-priority
B.    class app-data
C.    class internet
D.    class default

Answer: A

QUESTION 57
Refer to the exhibit. The customer has an MPLS Layer 3 VPN service CE-A is not able to ping the CE-B loopback address 10.60.6.6 CE-A is able to ping the CE-B network interface address 172.16.60.66. What must be added to the configuration to allow the loopback ping to work?
571

A.    The PE-B configuration needs a neighbor 10.60.6.6 command added
B.    The PE-B configuration needs interface loopback0 added under vrf red area 0
C.    The CE-B configuration needs to static route added for the PE-B connected interface
D.    The CE-B configuration needs network 10.60.6.6 under router ospf 1

Answer: D

QUESTION 58
Refer to the exhibit. What type of MPLS LAYER 3 VPN configurations is represented?
581

A.    Simple two-VPN scenario
B.    Overlapping VPNs
C.    Central services VPNs
D.    Extranet VPNs

Answer: C

QUESTION 59
Your company has decided to deploy a MPLS network with VPNs. The customer that will be using the network is demanding service level agreements with your company. What OSS system should violations be sent to?

A.    RMON
B.    event management system
C.    asset management system
D.    CNR
E.    IP SLA

Answer: B

QUESTION 60
Which protocol must be enabled to successfully deploy MPLS TE?

A.    OSPF
B.    IS-IS
C.    EIGRP
D.    BGPv4
E.    MP-BGP
F.    RSVP

Answer: F

New Passleader Cisco 642-780 Practice Tests Dumps Download For Free